Water Service Grade PES Cartridges are cost-effective alternatives to General and Electronic Grade Cartridges for a variety of aqueous based fluids.Water Service Cartridges are manufactured from an inherently hydrophilic PES membrane. The cartridge offers excellent flow characteristics, extended service life, and broad chemical compatibility.

Flow Rate

Typical Applications
Deionized Water Systems
General-Use Water Filtration
Liquid Clarification
Recirculating Fluids
Chemical Filtration

Construction Materials
Membrane ...................Polyethersulfone (PES)
Support Media .........................Polypropylene
End Caps .................................Polypropylene
Center Core .............................Polypropylene
Outer Support Cage ...............Polypropylene
O-rings/Gaskets .....................Buna, Viton, EPDM, Silicone, Teflon® Encapsulated Viton

Sanitization/Sterilization
Filtered Hot Water ...........88° C for 30 Minutes
Steam Sterilization...121°C for 30 min, multiple cycles
Chemicals: Cartridges are chemically compatible with most chemicals and sanitizing agents.
Note: Stainless insert option needed for all cartridges being hot water sanitized or steam sterilized.

Dimensions
Length:
10 to 40 inches (25.4 to 101.6 cm) nominal
Outside Diameter:
2.70 inches (7.0 cm) nominal

Maximum Recommended
Operating Conditions
Maximum Temperature ................176°F (80°C)

Maximum Differential Pressures
Forward ..........................50 psi (3.4 bar) at 20°C
Reverse ..........................40 psi (2.7 bar) at 20°C

FDA listed materials
Manufactured from materials which are listed for food contact applications in title 21 of the U.S. Code of Federal Regulations.

Toxicity
All polypropylene components meet the specifications for bilogical safety per USP Class VI - 121°C for plastics.

GWPES	Pore Size	A	Length	C	End Cap Code	O-Rings/ Gaskets	Adders
	0.04		10 (25.4 cm)		2 = DOE - Flat Gasket	B = Buna	I = Stainless Steel Insert
	0.1		20 (50.8 cm)		3 = 222 w/ Fin	E = EPDM	HP = Heavy Poly Core
	0.2		30 (76.2 cm)		4 = 222 w/Flat Cap	S = Silicone
	0.45		40 (101.6 cm)		6 = 226 w/Flat Cap	V = Viton
	0.65				7 = 226 w/Fin	T = Teflon Encapsulated Viton
	0.8				16 = 213 Internal O-Ring

Ordering Information